MINELAB MANTICORE: DATA & PERFORMANCE

This is an open discussion forum about metal detecting. Please be generally polite and respectful. Please note that Dankowski Detectors now has Terms of Use provisions. Nothing has really changed, its just now everything is written down for the sake of those who in the past liked to argue. If anybody sees anything unreasonable or disagreeable in the Terms of Use, please let me know.
NASA-Tom
Posts: 263
Joined: Sun Feb 11, 2024 2:04 am

Re: MINELAB MANTICORE: DATA & PERFORMANCE

Post by NASA-Tom »

I know that I have discussed/posted "similar topic" before; yet, the following is worth reiteration:

Manticore (EQX & XP Deus/II)

1901 church. 90' X 75' front lawn.

Education/Quest = Recovery Speed ...............Real-World performance: Proof.

With Recovery Speed on '4'......... hunt this 90' X 75' front lawn....... until totally satisfied that no more coins left...to be found. =
17 coins found.

Now hunt the exact same property......with exactly the same settings......... except Recovery Speed on '2'.=
11 more coins found.

Thoughts/Summary =
Yes..............most of the additional 11 coins found....were deeper. (and older).
Knowing this would happen........ I was still (somewhat) startled when I would find/detect another coin.
Sooooooo........ with each/every one of these 11 additional coins........ I HAD to switch back to Recovery Speed '4'......... just to see WHY they were missed. Nutshell: 9 (of the 11) coins were missed.... in Speed 4.... because the coins were (just barely) too deep. The remainder 2 coins COULD be detected in Recovery Speed 4; yet, the coil approach angle-of-attack was rather critical........and...... these two coins....were quite weak in signal-strength......with the exact/correct coil angle-of-attack. ANY interference....... and they were undetectable.

Moral of the story:
1. DEPTH is critical!!!
2. Enhanced adjacent target separation is critical!!!

Also.................................... I hunted Recovery Speed 4 FIRST....this time................................. because the last several time I performed this exact test...... I always used Speed '2' first.
It does not matter WHICH speed you hunt in....first. Just as long as you hunt the site (eventually) .... using BOTH speeds.

Note = Some dirt is SO magnetic (mineralized)...... that the EQX/Deus/Manticore will not let you hunt the bad dirt.... in slower recovery speeds.
NASA-Tom
Posts: 263
Joined: Sun Feb 11, 2024 2:04 am

Re: MINELAB MANTICORE: DATA & PERFORMANCE

Post by NASA-Tom »

A quick addendum:

I just finished hunting this exact property again............... but with Recovery Speed 6. Results =
One more coin was found.
Real-World resultant!
User avatar
JCR
Posts: 92
Joined: Sat Feb 10, 2024 8:00 pm
Location: East Texas, USA

Re: MINELAB MANTICORE: DATA & PERFORMANCE

Post by JCR »

A good reminder for us all. Thanks
Chris
steveg
Posts: 35
Joined: Tue Feb 13, 2024 8:00 pm

Re: MINELAB MANTICORE: DATA & PERFORMANCE

Post by steveg »

This is great information, NASA-Tom. Thank you for sharing. Very fascinating, how recovery-speed changes have such an effect on what your machine is able to "see."

Steve
Post Reply