Page 1 of 1
Manticore Processing
Posted: Tue Nov 04, 2025 10:40 pm
by broadfield
Hi,
Curious to know the processing methods used in Manticores all terrain programs, the Deus 2 uses subtraction or addition, does the Manticores use these methods or something else? Thanks
Re: Manticore Processing
Posted: Wed Nov 05, 2025 8:18 pm
by NASA-Tom
One of the primary differences in the All-Terrain Modes (on Manticore)........ is the grouping of frequencies. For instance:
All Terrain - Low Conductors.......... utilizes a grouping of higher freq's.
All Terrain - High Conductors......... utilizes a grouping of lower freq's.
There is also different factory presets.....between each individual Mode.
And yes.......... algorithmically...... there are (differing) subtraction & addition parameters....... between all the Modes.
Re: Manticore Processing
Posted: Wed Nov 05, 2025 11:21 pm
by broadfield
NASA-Tom wrote: ↑Wed Nov 05, 2025 8:18 pm
One of the primary differences in the All-Terrain Modes (on Manticore)........ is the grouping of frequencies. For instance:
All Terrain - Low Conductors.......... utilizes a grouping of higher freq's.
All Terrain - High Conductors......... utilizes a grouping of lower freq's.
There is also different factory presets.....between each individual Mode.
And yes.......... algorithmically...... there are (differing) subtraction & addition parameters....... between all the Modes.
Thanks Tom, out of interest which all terrain modes uses subtraction and which use addition?
Its also been suggested that the Manticore dynamically adjusts the frequency ranges based on ground feedback as you sweep, im doubtful its that intelligent though?
Re: Manticore Processing
Posted: Wed Nov 05, 2025 11:44 pm
by NASA-Tom
Gosh! That's pushing into proprietary stuff!!!
Re: Manticore Processing
Posted: Thu Nov 06, 2025 7:56 am
by broadfield
NASA-Tom wrote: ↑Wed Nov 05, 2025 11:44 pm
Gosh! That's pushing into proprietary stuff!!!
Understood but knowing which all terrain programs use addition or subraction surely isnt giving away trade secrets?
Re: Manticore Processing
Posted: Thu Nov 06, 2025 8:54 pm
by NASA-Tom
Possibly not!....... but sure pushing a gray area!!!!
Re: Manticore Processing
Posted: Tue Nov 18, 2025 5:04 am
by broadfield
OK thanks Tom, putting the question a different way then, soaking wet pasture field which program would you start with?
Re: Manticore Processing
Posted: Tue Nov 18, 2025 8:58 pm
by NASA-Tom
In that case....... I would start with All Terrain - High Conductors. IF there's too much feedback (due to wet mineralization)..... then go straight to Beach - General Mode.
Re: Manticore Processing
Posted: Wed Nov 19, 2025 7:13 am
by ianp
NASA-Tom wrote: ↑Tue Nov 18, 2025 8:58 pm
In that case....... I would start with All Terrain - High Conductors. IF there's too much feedback (due to wet mineralization)..... then go straight to Beach - General Mode.
That's interesting, why not All Terrain General as it's on pasture Tom?
Re: Manticore Processing
Posted: Wed Nov 19, 2025 9:55 am
by NASA-Tom
Because/do-to: the grouping of lower freq's "usually" (in most cases)......can handle wet mineralization better......(((less attenuation))).
A Salt mode (Beach Modes) utilizes even lower freq's.....AND employs the proper phase-shift-angle for wet salt......should your dirt have (even trace-element) salt(s).