Xp Deus 2 Version 3.10 update released - this is non beta version

[Tnsharpshooter]

The higher the Freq............. the more hyper-sensitive the unit(s) will be with the #5 shot.,.,.,., and the ID's will 'express' accordingly.

Did you use All Terrain - High Conductors.....when you had the dime under the #5 shot? (This is important)!
Any time the camera was close to the faceplate of the detector.......... the camera nearly completely missed the faceplate. (Due to camera fixed position). Plus....... the 'glare' was blinding. It's difficult to capture a mirror/glass faceplate!

There is a misnomer in regards to Recovery Speed (either detector).
Recovery Speed is designed for ADJACENT targets. (((In other words: Lateral separation))).
Targets that are superimposed (on top of each other......with-or-without: vertical separation)..... Recovery Speed will have minimal effect.

I didn’t show ATHC when showing the shot. I did show it using small foil masker comparing modes.
I just showed speed setti;g changes. Because there are always those out there that try to find fault with my results - they may say I.e you didn’t check with X speed.

[NASA-Tom]

I'm not trying to find fault in you........ and your videos are fairly comprehensive!

But........ just trying to bring up: All Terrain - High Conductors: is substantially better at unmasking through low conductors (like foil & Birdshot).

[Tnsharpshooter]

https://m.youtube.com/watch?v=h-uBA5FqkgE&t=29s